UM_READDUMP Error STASH 0, 409 (Surface Pressure)

Unified Model
1

Hello CMS,

I am unable to get past the following error (suite id u-dg192).

Error code: 6
[0] ? Error from routine: UM_READDUMP
[0] ? Error message: UM_READDUMP Dump does not match STASH list: Wrong processing code.
[0] ? Error from processor: 80
[0] ? Error number: 64

I have referred to this earlier post and solution by Ella @shakka → UM_READDUMP STASH processing code error

These are the things I have tried based on her post:

  • Running the tidystashtransform macro
  • Tried removing and re-adding them and not running the macro, as suggested by Paul Field.

These steps don’t help.

If I disable this STASH- the model runs fine.
Please advice. Should I be removing all the STASH and add them manually again- a very cumbersome task.
Best Wishes
Sid

2

Hi Sid

If I disable this STASH- the model runs fine. which stash? Which task?

Grenville

3

Hi Grenville

STASH 0, 409 (Surface Pressure)

Task - Alps_km1p5_RAL3_um_fcst_001

Sid

4

Sid

0 409 is a prognostic but the model does not include that prognostic. Try adding item 222 from section 16 instead.

Grenville

1 Like
5

Hello Grenville

Thanks for that suggestion. I am dumping pressure at theta levels, so might just extract the lowest level data assuming it to be the surface level fields. That’s still 5 m AGL, so not much of an error expected. 16, 222 would be Pressure @MSL and may not be a good STASH over orographic regions which I am dealing with rn, so may have to disable 0, 409 to keep the model going. Many thanks
Sid

6

This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.